![]() Cut them in half and wire them up to one of those aircraft connectors with the seal ( which are typically used on the Chinese knockoff Rework / soldering stations ). ![]() So, BNC Wires Female to Female should be available on eBay for a low price. ![]() I wanted to look for a 1x4 layout and check the measurements because I could use that for my solution and use heat-shrink wrap around it but I think there is a better way. I did find a BNC Female 4 connections in 1 2x2 layout which is 36x31x32mm so it could fit, but it'd be bulky. One of the ideas being passed around was to have a single module and 4 BNC connectors mounted to it - there are a lot of problems with this: There isn't much room, it doesn't fit with the current design so it'll need to be modded or a new case needs to be 3D printed meaning less available and depending where you mount the wires they could be a burden. but to be of most use there should be a different way. ![]() I keep seeing videos showing people either removing the ends of kelvin clips, or cutting the wires and soldering them to one of the DE-5000 modules but this isn't future-proof. I ordered another TL-22 off eBay for $20 USD ( I could've paid $18.88 USD on Amazon for TL-21 but the alligator clips are useless to me and short, but the tweezers I can attach other ends to and it'll be an upgrade from my current ones and then I can use the box for something else ). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |